Sunday, 25 August 2013

Ways To Get Rid Of Noise In Your Car Or Truck Stereo System

By Eric Glynn


Noise in your car radio can come from many places within the car and under the hood. The sounds can be whines, clicks, rumbles or merely plain old static. Is the noise on your AM radio or in the FM stereo? Would it be heard whenever you are playing a tape or CD? What form does this take? These are just some of the many questions that you can answer with a few easy checks. There are lots of products to the market made to suppress noise in your car radio. Most will not be required as well as a doit-yourself car audio checkup can most likely locate the problem.

Check the antenna. In the event your vehicle antenna is mounted to the chassis, it is outside in the elements. Rain, wind, snow and sleet can give rise to a connection issue. Have you got a flag, blossom or other item mounted to the antenna? Wind stress to the item can cause unwanted vibrations that may loosen the antenna connection.

Try to change the antenna to see whether it truly is loose. If it generates static, tighten the link.

AM radio is Amplitude Modulated and will pick up engine noise in the event the radio is poorly grounded or if new spark plug wires are desired. Make sure the ground wire to the rear of the radio is tightly linked to the chassis.

Pay attention to the FM stereo with all the vehicle engine running. A highpitched whine could signal a poorly grounded alternator. A great solid ground in the alternator to the chassis is important.

Turn the radio on using the motor switched off and utilize the turn signals and brakes. Clicking sounds could suggest a bad ground to the radio.

Fix most car audio problems by checking the integrity of the ground connections to the noise producers like spark plugs, alternator, heater and air conditioner motors within the automobile. Connections for many parts of your vehicle's electrical system must certanly be great and the integrity of each one must be checked until the supply of your sound noise is located.

When possible, obey the engineer's one-hand rule when working with electrical wiring. Whenever using any cable carrying an electrical charge keep one hand in your pocket. This will assist you avoid electrical shock. Be careful when examining any electrical wiring. Don't run the engine within an enclosed space while doing your sound check.




About the Author:



No comments:

Post a Comment